Anycubic I3 Mega – print size hacks

With below modifications, size of printing was changed to  210 x 210 x 233 mm. First of all, the gantry was risen and the connector of hot end and cooling fans were relocated to back of lead screw.

  1. Gantry was risen by (i.e. 28 mm) fastening two screws instead 4 screws and lowered down the end stops of Y-axis carriages.

2. Connector for cables of two cooling fans and hot end was relocated to back of slides with the below connector enclosure and a stool. 3. Machine setting in Cura shall be changed and Marlin firmware shall be used. Search in Configuration.h for Z_MAX_POS 206  and change it to 234 (i.e. 233+1) https://www.youtube.com/watch?v=6Urru7IsFrI

 

發表回覆

你的電郵地址並不會被公開。 必要欄位標記為 *